How to Setup a Cox Control Handle
for E-Z Adjustment


Loop line through


Wrap center post with a rubber band

Pull one side to make a adjustment

This is a trick from Bill Osborne. The best way to setup a Cox Control Handle with dacron lines, it to loop the line through from bottom to the middle adjustment hold to the top hole as one continuous loop. Once you have both line equal, do the tie it around the post. Instead of wrapping one side of the line to the post, just use a rubber band to wrap around the post to add friction to the line. Now you can easily adjust the lines to your models neutral position by pulling it through, either from the top or from the bottom depend on the amount need to make the control neutral.